Investigate the effect of various cutting parameters on the surface roughness of aluminum alloy 5052 by using Taguchi method
DOI:
https://doi.org/10.65405/2yvdct20الكلمات المفتاحية:
surface roughness, CNC, Taguchi, parameters, ANOVAالملخص
The characteristic surface finish of machining is a key indicator of product quality and an indispensable customer requirement. Taguchi robust parameter design for optimizing surface finish in the turning of 5052 AL alloy using carbide cutting has been utilized in this paper. Using the Taguchi method for AA5052 aluminum alloy machining reveals that feed rate, cutting speed, and depth of cut significantly impact surface roughness, with feed rate often being the dominant factor, followed by speed, then depth. The results showed that lower feed rates (e.g., 0.1 mm/rev) and higher cutting speeds (e.g., 900 rpm) generally yield the best (lowest) surface roughness (Ra), while optimal depth of cut varies but often favors lower values. ANOVA and Signal-to-Noise (S/N) ratio analyses confirm parameter significance, allowing prediction of optimal settings for improved quality. Finally, we developed the relationship between cutting parameters and response using MINITAB-16 and performed regression analysis. The predicted values were compared with the experimental values, and it was observed that both values were very close; hence, the models prepared were more accurate and adequate.
التنزيلات
المراجع
[1 Kadirgama,, Surface roughness Prediction using Statistical Method, Euro Journal Publishing, 2009.
[2] SakirTasdemir , 2008 , Prediction using artificial neural network, AISI 1040 steel in dry cutting condition, Surface roughness of Turning process.
[3] N.E. Edwin Paul, P. Marimuthu and R. VenkateshBubu, ʻʻMachining Parameter Setting For Facing EN8 Steel with TNMG Insert, American International Journal of Research in Science, Technology, Engineering & Mathematics, vol. 3(1), pp.87-92,2013.
[4] Funderburk, S.R . (1999), ʻʻKey concepts in welding engineeringʼʼ .
[5] Julie Z. Zhang a, Joseph C. Chen b, E Daniel Kirby. 2006 ''Surface roughness optimization in an end-milling operation using the Taguchi design method'' . Journal of
[6] Julie Z. Zhang a, Joseph C. Chen b, E Daniel Kirby. 2006 ''Surface roughness optimization in an end-milling operation using the Taguchi design method'' . Journal of Materials Processing Technology 184, 233-239. [7] DalgobindMahto and Anjani Kumar , 2008. Optimization of Process Parameters in Vertical CNC machine Using Taguchi's Design of Experiments''.. Arab Research Institute in Sciences & Engineering,61-69.
[8] K. Jinadah, K. El-Mahdy, M. Zaher, M. Abo-Tabikh, Tawfeik. ''Taguchi Method''. Production Engineering and Mechanical Design Department, Faculty of Engineering, Mansoura University.
[9] cevdetGologlu, NazimSakarya, 2008. "The effect of cutter path strategies on surface roughness of material pocket milling of 1.2738 steel based on Taguchi method". Journal of materials processing technology 206, 7-15












